FYP 2 WEEK 6 (28/3/2022- 3/4/2022)
The Full Setup on Aquaponics Facilities
"The Shelves" & Software Simulation
"The Shelves" & Software Simulation
OBJECTIVES
- Continuing progress work on to produce the aquaponic systems
- Continuing progress work on to produce the aquaponic systems
CONTENTS
1. Continue the work on building of aquaponics facilities.
After the installation of my aquaponic system, the setup was completely done like fully piping installation and also all the parts were placed according to the planned flow.
Solid Waste & Bio Filter
Aquarium setup with full piping
Piping flow from fish tank to filter and gutter grow beds
Front view of my aquaponics setup
2. Software simulation code by using the Arduino IDE
Aquarium setup with full piping
Piping flow from fish tank to filter and gutter grow beds
Front view of my aquaponics setup
2. Software simulation code by using the Arduino IDE
All programming simulation work is done by using the Arduino Ide software application. This is because I use the NodeMcu ESP32 microcontroller to run the whole system.
Each defined code runs their own function such as the sensor will determined their measured parameters while the relay functionally to control the water pump to ON and OFF mode within a predetermined range.
SUMMARY
All programming simulation work is done by using the Arduino Ide software application. This is because I use the NodeMcu ESP32 microcontroller to run the whole system.
Each defined code runs their own function such as the sensor will determined their measured parameters while the relay functionally to control the water pump to ON and OFF mode within a predetermined range.
SUMMARY
- All the work done during the week went smoothly and the next steps progress can be continuously implemented.
Comments
Post a Comment