FYP 2 WEEK 7 (4/4/2022- 8/4/2022)
The Full Setup of Aquaponics Project,
Software Simulation & Workshop 3
OBJECTIVES
- To gain knowledge about the requirement needed in Chapter 4 (Result & Discussion) & Chapter 5 (Conclusion) from 3rd Briefing.
- Continuing progress work on the aquaponic setups.
CONTENTS
1. Workshop 3 Final Year Project (FYP) Thesis and Proposal Writing
In week 7, the general briefing was conducted on Microsoft Teams that involved the FYP Diploma/FYP1/FYP2/IFYP students and the attendance is compulsory. The briefing was conducted by Sir Azmi Hashim.
Date: 6th April 2022
Time: 2:30 PM - 4:30 PM
Venue: Online Microsoft Teams
2. Continue the work on completing the aquaponics facilities.
The progress work of my aquaponic system is continued by the installation of a solar system as an energy source to the entire system of this facility.
30W Solar Panel
Solar Charger Controller
3. Wi-Fi simulation software by using the Arduino IDE and Blynk Display
3. Wi-Fi simulation software by using the Arduino IDE and Blynk Display
After the programming code system on this aquaponic system in functionally well towards the sensors and relay. .Now the next step is to define the Wi-Fi function which is to provide the network variable to the esp32 microcontroller. So if the internet able to connected, the blynk application can be used for display all the measured parameter from the sensor.
After the programming code system on this aquaponic system in functionally well towards the sensors and relay. .Now the next step is to define the Wi-Fi function which is to provide the network variable to the esp32 microcontroller. So if the internet able to connected, the blynk application can be used for display all the measured parameter from the sensor.
SUMMARY
- All the work done during the week went smoothly and the next steps progress can be continuously implemented.
Comments
Post a Comment